TUTORIAL FOR BEGINNERS
It’s a low cost USB interface Board that provides cool interface to your
computer and it can be used to control various devices like DC Motor,
Stepper motor ,Servo ,relay switch etc with your laptop or any computer
with a USB port and dot net framework installed. A small C# program
communicates with the hardware to issue commands to set the pins of the
Microcontroller. Inspite of LEDS u can use it as control singnals for
your project.
USB controlling is more cool than that of parallel port. Rather laptops
now days don't come with parallel port, so a USB port is a bit easy
replacement.The Video will show u my usb Interface Board, see its
working , i will post links for making your own Micro-controller board .
As Audrino Boards are very costly and if are beginner with
microcontroller then you really don’t wanna invest so much on a audrino
board for the 1st time on microcontroller, rather if you make one
mistake then you microcontroller is fumed (like exceeding Vmax of
microcontroller).
The Video below will show u my USB DEMO INTERFACE DEVELOPMENT BOARD, see
its working in the end i will post links for making your own
Micro-controller board .
I WILL PUT TUTORIAL TO MAKE THIS BOARD AT THE END PART.
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment